I’m sure that all crafters and embroiders will be happy with this bracelet as it’s made of spools! You’ll need epoxy resin, mold release and conditioner, 9 mini wooden spools, ⅝” tall x ½” diameter, spray acrylic sealer or Mod Podge, colorful thread or embroidery floss. Gripping each spool firmly with needle-nose pliers, use a hacksaw to carefully split 9 wooden spools in half. Use fine grit sandpaper to smooth and even out the cuts on the back of each split spool. Test each spool in the resin mold to make sure it fits inside easily, with a bit of room to spare. If a spool is too thick, use the sandpaper to remove additional width from the back, then check the fit again. Continue reading the tutorial here.
